Back to top

PC-controlled Vicat needle apparatus, 6 points for gypsum and cement glue

Article Number: 1.0366.GZ

EN 196-3, EN 13279-2, DIN 1168
EN 480-2 optional equipment is required *
The six measuring points (2 x 3) are installed in a
rectangular trough. Tests can be performed in air or
in water bath with constant temperature (heat
exchanger and cooler for constant water temperature
of 20±1°C), with programmed test sequences. The unit
records initial and final set time, as well as setting plots
automatically. After each penetration the Vicat needle is
automatically cleaned.

Scope of deliveryBase unit as a table model with the control unit and standard software
for programmable test sequences and for data recording
6 x Vicat moulds (conical hard plastic ring) 70/80 dia. x 40 mm
6 x Vicat moulds (conical hard plastic ring) 65/75 dia. x 40 mm
6 x glass base plates, 120 mm dia.
6 x centerings for Vicat moulds (conical hard plastic ring) 70/80 dia. x 40 mm
6 x centerings for Vicat moulds (conical hard plastic ring) 65/75 dia. x 40 mm
2 x pair of cleaning brushes
1 x tee wrench, 1.25 mm
1 x tee wrench, 2 mm
2 x spare glass plates, 120 mm dia.
2 x spare initial-set needles, 1.13 mm dia.
1 x replacement cone
Filter sponge coarse
Filter sponge fine
Serial cable
USB/RS232 adaptor
Mains cable
Dimensions(W x D x H) = 700 x 600 x 600 mm
Weight: 62 kg
110 - 230 V / 50 - 60 Hz

Important: For operation, a standard PC or laptop is needed, which is not included in the scope of delivery.

* For standard EN 480-2 the plunger with additional weight 1.0366.12 and optionally the extra cooling unit 1.0366.13 for a test temperature of 5°C are required.